How to run the project

After the project passes compile, it can be put to run on the real machine. According to different equipment models, there are several operating modes as follows:

Use WIFI to connect devices quickly

This method only supports models with WIFI, and the currently supported device models are:

• sw480272043B_CW 4.3inch
• sw480272043B_CWM 4.3inch
• sw80480043B_CW 4.3inch
• sw48854050B_CW 5inch
• sw80480070A_CW 7inch
• sw80480070A_CWM 7inch
• sw80480070AI_CW 7inch
• sw80480070AI_CWM 7inch

• sw10600070A_CW 7inch

  Product model description

After confirming that the device supports WIFI, follow the steps below to complete the configuration:

1. First enter the WIFI setting activity of the device, and connect the device to the same wireless network as the computer, that is, the computer and the machine must be connected to the same WIFI. (If a different network will cause the subsequent download procedure to fail).
2. After the wireless network connection is successful, click the menu in the upper right corner of the WIFI setting activity to check the IP address of the device.
3. At this time, go back to the development tool on the computer, on the menu bar, select the menu FlywizOS -> ADB Configuration, in the pop-up box, select Net for the ADB connection method, and Fill in the IP address of the device and save the application.
4. After completing the connection configuration, select the Download and Debug menu item, it will temporarily synchronize the project code to the connected device to run.

Fast operation with USB connected device

For models without WIFI function, almost all support USB cable connection. Note: If there is WIFI function, the USB cable connection is invalid.

1. Connect the device to the computer via a USB cable. If the computer can recognize the device as an Android device, the connection is normal. If you can't connect normally, the computer prompts a driver problem, you can try Download Driver.
2. When the computer recognizes the device correctly, return to the development tool on the computer, in the menu bar, select the menu FlywizOS -> ADB Configuration, in the pop-up box, select the ADB connection method USB and save.
3. After the configuration is complete, select the Download and Debug menu item, it will temporarily synchronize the project code to the connected device to run.

Boot from TF card

If for other reasons, both USB and WIFI cannot be used normally or are occupied, you can start the program from the TF card with the help of a TF card. For specific steps, please refer to Start the program from the TF card